I figured with the downtime while I get the carbs done (dropping those off tomorrow), I would address some of the electrical issues. I found some loose wires while I had the headlight off. I tightened some of the connectors, hooked up the new left hand controls, and yeah – high beans now work. The tach’s light is also now working, but still not the speedometer light or guage itself. Also, the right turn signals are now working (sort of – but thre’s either a loose wire or the relay is bad because they blink ultra fast). The left front turn signal is working, but not the rear. I put in some different bulbs, but I’m not sure if they are working either (pulled from the CB360).
Anyway, electrical is looking pretty good – just a few loose ends. I need to find a new rubber boot for hte high beam indicator light…good luck!!!
Loading ...
Thanks Katy. I really appreciate the feedback.
Brian
Pretty good post. I just found your site and wanted to say
that I’ve really liked browsing your blog posts. In any case
I’ll be subscribing to your feed and I hope you write again soon!